2006 jeep commander starter location




Article Navigation:
  • Photo
  • SOLVED: Jeep Commandercant find the starter??? - Fixya
  • Video
  • RELATED PAGES
  • I have tried all remedies 2 restart jeep,'08 Commander,it only clicks. Under the door is a pictorial displaying location of each, pull and replace ignition starter fuse 40A. It is located All Warning Lights on 06 Commander and Wont start up !!!.

    Order Jeep Commander Starter online today. Free Same Day Learn More. Your Current Location: SUMMER AVE - MEMPHIS, TN - Store Info.

    Equip cars, trucks & SUVs with Jeep Commander Starter from AutoZone. Your Current Location: SUMMER AVE - MEMPHIS, TN - Store Info.

    My commander is unpredictable. Level 3 Expert Answers. Remove the brake pads from the caliper. Jan 19, Jeep Commander. Jul 12, Jeep Commander.

    Reply Page 1 of 2 1 2. I am trying to replace my starter, I have read online that you must move the drive shaft, can someone tell me how to remove the front drive shaft? Did you go see where the starter was for your self. I would be surprised if the drive shaft needed to me removed let me see if I can find it in the manual. To view links or images in signatures your post count must be 10 or greater.

    You currently have 0 posts. Stop by and like the page To view links or images in signatures your post count must be 10 or greater. Which engine do you have and I'm guessing you have 4x4. Originally Posted by tmrose View Post. Just going to post this as well I'm looking up the drive shaft. Disconnect and isolate negative battery cable. Raise and support vehicle.

    If equipped with 4WD, remove front drive shaft. If equipped with 4WD and certain transmissions, a support bracket is used between front axle and side of transmission. Remove 2 support bracket bolts at transmission. Pry support bracket slightly to gain access to lower starter mounting bolt.

    Remove two bolts 3 if equipped with an automatic transmission. Move starter motor 4 towards front of vehicle far enough for nose of starter pinion housing to clear housing. Always support starter motor during this process, do not let starter motor hang from wire harness.

    Tilt nose downwards and lower starter motor far enough to access and remove nut 2 that secures battery positive cable wire harness connector eyelet 1 to solenoid battery terminal stud. Do not let starter motor hang from wire harness. Remove battery positive cable wire harness connector eyelet 5 from solenoid battery terminal stud. Disconnect battery positive cable wire harness connector from solenoid terminal connector receptacle. That is great, thank you so much for your help. I've never done this repair before but here is the instructions out of the SM.

    I'm sure someone will chime in and give you some extra advice on things that may have helped them get this done.

    I personally would not remove the whole thing unless I had to just pull the one side off and see if that gives you enough room to wiggle the starter out.

    I can go look at mine as well here in a little bit since we have the same engine. With vehicle in neutral, position vehicle on hoist. Mark a line across the axle pinion flange 1 , propeller shaft 2 , flange yoke 3 and transfer case for installation reference.

    Support the transmission and the transmission crossmember. Remove propeller shaft 1 from transfer case flange 2. Remove propeller shaft 1 from axle pinion flange 2.

    06 jeep commander 5.7 hemi, starter removal without dropping the driveshaft or crossbar



    • Подписаться по RSSRSS
    • Поделиться VkontakteVkontakte
    • Поделиться на FacebookFacebook
    • Твитнуть!Twitter

    Leave a Reply

    Return to Top ▲TOP ▲